1. These operators use a step-down transformer to achieve 115 VAC operating voltage.
2. Optional factory installed DC powered drive system provides an automatic method to open the gate when primary (AC) power fails. Breakaway Barrier Arm option not available when equipped with Convenience Open option.
3. Breakaway Arm, available with aluminum arm type only.
4. This will be two-piece aluminum arm (reduces shipping cost).
5. Maximum length of arm when using a folding arm kit is 12 ft.
Operators are designed so they can be mounted on either the left or right hand side of the roadway.
OPTIONS
BARRIER GATE OPERATOR
Left or Right Hand Mount
HIGH USAGE SINGLE LANE TRAFFIC CONTROL
Magnetic Electronic Limit Controls
Auto-Close timer 1-23 seconds
P.A.M.S. (Perimeter Access Management System) sequence with a Slide or Swing Gate Operator
Up Input Memory Buffer
Down Memory Option
Multiple Up Commands
Port for plug-in Open (Up) Detector
Port for plug-in Reverse (Down) Detector
Programming Switches
Built-in Power On/Off Switch
DKS Pedestrian Protection System: The system reverses Barrier Arm if person is detected, and lowers Barrier Arm if unauthorized vehicle enters. Requires DKS 9411 Loop Detector and a photo-beam.
TAP HERE FOR PRINTER VERSION
Pedestrian Protection System Available
ELECTRICAL
Access Control Solutions since 1948
Environmental: 10°F to 140°F (-12°C to 62°C)
Thermostatically Controlled Heater Kit recommended for colder environments.
1601 shipping weight approximately 140-160 lb (63-72 kg) Arm Kit: 15 lb (7 kg)
1601 PARKING CONTROL
Designed for single lane (14 ft maximum) vehicular control in high traffic applications
Electronic Limit Settings
Operators are designed so that they can be mounted on either the left or right hand side of the roadway
Lighted and Breakaway Arm Kits available. Low headroom Folding Arm Kits also available
Pedestrian Protection System available (See below for system requirements)
5-Year Limited Warranty
Primary Reduction is provided by a 60:1 Worm Gear Reduction System running in a continuous oil bath
Arm rotates 90° in approximately 2.5 seconds
G90 Galvanized Steel Housing, painted white
Fail-Secure Mechanical Release Method
Left- or Right-Hand Mount
360º gear box rotation before the motor changes direction. This provides for smooth operation, evens wear across the entire gear-box, and increases the life span of the operator
it’s aware – even when they’re not
MECHANICAL
Octagonal Lighted Signal Arm Option
Aluminum Octagonal Lighted Barrier Arm: Octagonal Arm LEDs are RED when the arm is in the down position and turns to GREEN when the arm rotates to the full up position.
Breakawy Hardware Kit: llows arm to swing out of the way in the event that a vehicle fails to stop at a lowered Arm. The system is easily reset by simply snapping the Arm back into place. For Aluminum Arms only and not available with Convenience Open option.
2-Piece Arm 14 Ft (4.27 m): The two-piece Aluminum Arm Ships in a 7-ft (2.13 m) long box to reduce shipping cost. Two-piece design does not except light kit.
TECHNICAL FEATURES
GATE TRACKER
MISCELLANEOUS
light the way for customers to exit easily and safely with signals and sensors
COMMERCIAL • INDUSTRIAL
reduce maintenance costs
TM
MEMBER:
Breakaway Arm Option
120 Glasgow Avenue, Inglewood, California 90301 U.S.A.
Tel: 310-645-0023 FAX: 310-641-1586
www.doorking.com© 2022 All Rights Reserved. Product specifications may change without notice. Rev. 1/22
Reporting output provides operator data to a DKS 1833, 1835, 1837 or 1838 access control system (requires 2358 expansion board)
Octagonal Lighted Signal Arm Option
Designed for single lane (14 ft maximum) vehicular control in high traffic applications
Electronic Limit Settings
Operators are designed so that they can be mounted on either the left orright hand side of the roadway
Lighted and Breakaway Arm Kits available. Low headroom Folding Arm Kits also available
Pedestrian Protection System available (See below for system requirements)
5-Year Limited Warranty
Primary Reduction is provided by a 60:1 Worm Gear Reduction System running in a continuous oil bath
Arm rotates 90° in approximately 2.5 seconds
G90 Galvanized Steel Housing, painted white
Fail-Secure Mechanical Release Method
Left- or Right-Hand Mount
360º gear box rotation before the motor changes direction. This provides for smooth operation, evens wear across the entire gear-box, and increases the life span of the operator
Environmental: 10°F to 140°F (-12°C to 62°C)
Thermostatically Controlled Heater Kit recommended for colder environments.
1601 shipping weight approximately 140-160 lb (63-72 kg) Arm Kit: 15 lb (7 kg)
Operators are designed so they can be mounted on either the left or right hand side of the roadway.
Reporting output provides operator data to a DKS 1833, 1835, 1837 or 1838 access control system (requires 2358 expansion board)
Left or Right Hand Mount
Left or Right Hand Mount
Reporting output provides operator data to a DKS 1833, 1835, 1837 or 1838 access control system (requires 2358 expansion board)
light the way for customers to exit easily and safely with signals and sensors